Water Quality InformationWritten By Actual Experts

Ernesto Esquivel  |  Water Nerd
**Updated August 2, 2019 to include current data

For Hydroviv’s assessment of Louisville, Kentucky’s tap and drinking water problems, we collected water quality test data from Louisville and the U.S. Environmental Protection Agency. We cross referenced Louisville water quality data with toxicity studies in scientific and medical literature. The water filters that we sell at Hydroviv are optimized to filter out contaminants that are found in Louisville’s drinking water.

Where Does Louisville Source Its Drinking Water?

Louisville sources its drinking water from the Ohio River. The utility provider, Louisville Water, treats and distributes drinking water to the metropolitan area as well as surrounding counties, including; Bullitt, Hardin, Nelson, Oldham, Shelby, and Spencer.

Lead In Louisville’s Drinking Water

Lead enters tap water through old lead service pipes and lead-containing plumbing. 10% of sites that were tested for lead had concentrations over 4.7 parts per billion, and the highest level collected was 10.2 parts per billion. The City of Louisville only received data from 50 residential taps, so the small data set may not be representative of the actual scope of the lead problem. Environmental Protection Agency, Center for Disease Control and American Academy of Pediatrics all recognize that there is no safe level of lead for children. Additionally, once water hits lead plumbing and lead fixtures, these measurements will increase significantly. Houses built before 1986 were most likely built with these types of fixtures. Lead exposure can cause developmental issues, lowered IQ, and damages to the kidneys and brain.

Disinfection Byproducts In Louisville’s Drinking Water

DBPs are formed when chlorine or chloramine-based disinfectants are routinely added to the water supply to kill bacteria. EPA regulates two categories or DBPs: Total Trihalomethanes (TTHMs) and Haloacetic Acids-5 (HAA5). Concentrations of HAA5 averaged 27.3 parts per billion and reached levels as high as 46.1 parts per billion. The EPA Maximum Contaminant Level for this compound is 60 parts per billion. Concentrations of TTHMs averaged 27.8 parts per billion, but reached levels as high as 39.8 parts per billion. EPA’s Maximum Contaminant Level is 80 parts per billion for TTHMs. Disinfection Byproducts are a category of emerging contaminants which means they have been detected in drinking water but the risk to human health is unknown. Health and regulatory agencies have very little knowledge about the adverse health effects of DBPs, and their toxicity potential. EPA has stated that they have been linked to an increased risk of various types of cancers and problems with the central nervous system.

Chloramine In Louisville’s Drinking Water

Louisville disinfects its drinking water with chloramine, which is a disinfectant similar to chlorine. Chloramine is primarily responsible for what many Louisville customers report as the “bad taste” or “pool smell” of tap water. Most one-size-fits-all water filters use filtration media that doesn’t do a great job removing chloramine, but the filters that we design and build at Hydroviv for Louisville use a special filtration media that is purposefully designed to remove chloramine.

It’s important to note that only a handful of contaminants are required to be included in annual Consumer Confidence Reports, and that there are hundreds of potentially harmful unregulated contaminants that aren’t accounted for. If you’re interested in learning more about water filters that have been optimized for Louisville’s tap water quality, feel free to visit www.hydroviv.com to talk to a Water Nerd on our live chat feature or send us an email at hello@hydroviv.com.

Analies Dyjak  |  Policy Nerd

**Updated September 30, 2020 to include current data

For Hydroviv’s assessment of Norman, Oklahoma drinking water, we aggregated water quality test data provided by the city's Consumer Confidence Report, the U.S. Environmental Protection Agency and supplemental health information. We cross referenced the city’s water quality test data with toxicity studies in scientific and medical literature. The water filters that we sell at Hydroviv are optimized to filter out contaminants that are found in Norman's drinking water.

Chromium 6 In Norman's Drinking Water

Chromium 6 is a highly toxic metal that is currently unregulated by the EPA. Chromium 6 pollution is associated with metal processing, tannery facilities, chromate production, stainless steel welding, and pigment production. Norman, Oklahoma has some of the highest levels of Chromium 6 in the country. In the 2020 Consumer Confidence Report, the city of Norman tested for Total Chromium, instead of Chromium 6 - which is a far more toxic type of chromium. According to test data completed by the Environmental Working Group, the average concentration of Chromium 6 detected in Norman's drinking water was 39,300 parts per trillion. For a bit of perspective, these levels are as high as 1,965 times higher than the concentration determined to have negligible impact on cancer risk. EPA has acknowledged that Chromium 6 is a known human carcinogen through inhalation, but is still determining its cancer potential through ingestion of drinking water. Lung, nasal and sinus cancers are associated with Chromium 6 exposure. Acute respiratory disease, cardiovascular, gastrointestinal, hematological, hepatic, renal, and neurological distress are health effects associated with high levels of chromium 6 exposure.

Arsenic in Norman's Drinking Water

Norman, Oklahoma has a big problem with Arsenic in drinking water. The current levels of Arsenic in Norman drinking water are 14.4 parts per billion. The allowable level (also known as the Maximum Contaminant Level) for Arsenic in municipal tap water is 10 parts per billion. This is the first time in recent years that Norman has had high levels of Arsenic in drinking water. In previous years, Arsenic levels have been 2 parts per billion, which is well below the federal standard. 

Chloramine In Norman’s Drinking Water

While most municipalities use chlorine as the primary drinking water disinfectant, Norman’s drinking water is disinfected with chloramine. Chloramine is primarily responsible for what many customers report as the “bad taste” or “pool smell” of tap water. Concentrations were detected as high as 3.9 parts per million in treated water, which is just under the EPA Maximum Contaminant Level of 4 parts per million. Unlike chlorine, chloramine does not dissipate if a container of water is left in the refrigerator overnight. Most one-size-fits-all water filters use filtration media that doesn’t do a great job removing chloramine, but the filters that we design and build at Hydroviv for Norman use a special filtration media that is purposefully designed to remove chloramine.

Strontium In Norman’s Drinking Water

Strontium is an unregulated contaminant that was also detected in this years water quality report. Strontium naturally occurs in certain vegetables, grain, and livestock but is also a byproduct of coal and oil combustion. Concentrations of Strontium in Norman's drinking water were detected as high as 442 parts per billion. For a bit of perspective, this is twice as high as concentrations found in Oklahoma City. According to the Agency for Toxic Substances and Disease Registry, children are the most susceptible age group to the negative health effects associated with Strontium exposure. Bone growth can be effected if children ingest high enough concentrations through drinking water.

It’s important to note that only a handful of contaminants are required to be included in annual Consumer Confidence Reports, and that there are hundreds of potentially harmful unregulated contaminants that aren’t accounted for. If you’re interested in learning more about water filters that have been optimized for Norman's tap water quality, feel free to visit www.hydroviv.com to talk to a Water Nerd on our live chat feature or send us an email at hello@hydroviv.com.

Analies Dyjak  |  Policy Nerd

For Hydroviv’s city of Hartford, Connecticut's drinking water quality report, we collected water quality test data from Hartford's annual Consumer Confidence Report and the U.S. Environmental Protection Agency. We cross referenced water quality data with toxicity studies in scientific and medical literature. The water filters that we sell at Hydroviv are optimized to filter out contaminants that are found in Hartford's drinking water.

Where Does Hartford Source Its Drinking Water?

Hartford sources its drinking water from surface water reservoirs throughout the massive Farmington River Watershed. Because Hartford’s source water is entirely surface, pollution that’s discharged into the river or its tributaries has the potential to enter drinking water. Hartford, as well as the rest of the state of Connecticut, has a long industrial history. Hartford drinking water has contaminants associated with industrial activities such as Strontium, Barium, Vanadium and Chromium 6. Additionally, hormones caused by household waste were detected in the city of Hartford's most recent drinking water quality report. 

Lead In Hartford Drinking Water

Hartford is an older city, so it’s no surprise that lead contamination is a big problem. Lead enters tap water through old lead service pipes and lead-containing plumbing. 10% of sites tested for lead had concentrations over 4 parts per billion. But the highest level detected in Hartford drinking water was 148 parts per billion. Environmental Protection Agency, Center for Disease Control, and American Academy of Pediatrics all recognize that there is no safe level of lead for children. Additionally, municipalities are only required to test a handful of homes every few years, so the levels reported in Hartford’s annual water quality report might not reflect the lead levels in your tap water. Lead exposure can cause developmental issues, lowered IQ, and damages to the kidneys and brain.

Disinfection Byproducts In Hartford Drinking Water

Hartford also has a serious problem with disinfection byproducts or DBPs. DBPs are formed when chlorine-based disinfectants that are routinely added to the water supply to kill bacteria, react with organic matter. In this years report, concentrations of haloacetic acids ranged from 7.7 to 38.2 parts per billion and 15.3 to 72.8 parts per billion for trihalomethanes. For a bit of perspective, EPA’s maximum contaminant level for haloacetic acids is 60 parts per billion and 80 parts per billion for trihalomethanes. While Hartford's water quality is technically in compliance with EPA’s threshold, regulatory agencies have very little knowledge about the adverse health effects of DBPs, and their toxicity. EPA has stated that they have been linked to an increased risk of bladder cancer, as well as kidney, liver, and central nervous system problems.

Analies Dyjak  |  Policy Nerd

People often purchase bottled water under the assumption that it’s much safer than what’s coming out of their tap. Marketing schemes lead consumers to believe that large corporations bottle and distribute only the purest water from crystal clear springs. The reality is that bottled water isn’t as safe as people are led to believe. This article discusses the regulatory, environmental, and ethical dilemmas associated with bottled water.

How Is Bottled Water Regulated In The United States?

The Food and Drug Administration regulates bottled water, and the Environmental Protection Agency regulates tap water. People are often surprised to find out that the drinking water standards for both of these agencies are nearly the same. Under the Safe Drinking Water Act, certain chemicals that can enter drinking water must be allowable limits. This list of allowable contaminants and their concentrations are identical for bottled and tap water, with the exception of lead. FDA regulates lead more stringently because companies shouldn’t ever have a reason to use lead infrastructure in the bottling process. But still, there is an allowable level of lead in bottled water of 5 parts per billion. EPA, CDC, American Academy of Pediatrics and other health organizations have all acknowledged that there is no safe level of lead for children. FDA must follow their own monitoring guidelines, which are often much more lax than EPA’s for municipal tap water.

Where Does Bottled Water Come From?

A lot of bottled water companies are deceptive as to where they actually source their water. Companies are legally allowed to draw water from artesian wells, mineral water, natural springs, drilled wells, and municipal tap water. That’s correct. Bottled water companies are allowed to use the same treated water as municipal water systems. Additionally, companies are not legally required to disclose where they source their water on the bottle itself. Municipal water systems are actually much more transparent because they’re required to disclose information about source water in annual consumer confidence reports. Depending on the brand, there’s of course a substantial cost associated with purchasing packaged water.

Environmental Effects of Plastic Water Bottles

“Trash Island” in the Northern Pacific Ocean is probably the best physical example of the environmental effects of plastic and plastic water bottles. 91% of plastic isn’t recycled, meaning a majority of virgin, single-use plastic ends up in landfills or the environment. According to a 2016 study by the Ellen Macarthur Foundation, the ocean will contain more plastic by weight than fish in the year 2050. The main ingredient in plastic bottles is polyethylene terephthalate (Pet) which takes 400 years to decompose in the environment. Once degraded, dangerous chemicals such as Bisphenol A (BPA), polyvinyl chloride and other phthalates can leach into the environment. Not to mention the important natural resources required to make plastic water bottles. Plastic is a product of petroleum, which is a non-renewable fossil fuel.

The Ethics of Bottled Water

There’s also an ethical environmental dilemma associated with extracting water from a drought prone area, then selling it across the country or even the world. Nestle owns aquifers in California which has been experiencing a serious drought in recent years. Because Nestle is able to purchase expensive deep drills that municipalities can’t even afford, they’re able to continue extracting water business as usual. Additionally, native american tribes are significantly affected by bottled water companies. Tribes enter lease agreements with companies that are frequently violated. Even if they don’t have a legal agreement the same issues arise with the definition of “reasonable use” under the riparian law.